The Samba AD DNS Back Ends: Difference between revisions

From SambaWiki
m (Updated link)
m (Updated link)
Line 27: Line 27:


* [[BIND9_DLZ_DNS_Back_End|BIND9_DLZ DNS Back End]]
* [[BIND9_DLZ_DNS_Back_End|BIND9_DLZ DNS Back End]]
:* Requires BIND 9.8 or later installed and configured locally on the Samba Active Directory (AD) domain controller (DC). For additional information, see [[Setup_a_basic_BIND_installation|Setting up a Basic BIND Installation]].
:* Requires BIND 9.8 or later installed and configured locally on the Samba Active Directory (AD) domain controller (DC). For additional information, see [[Setting_up_a_BIND_DNS_Server|Setting up a BIND DNS Server]].
:* Requires knowledge about the BIND DNS server and how to configure the service.
:* Requires knowledge about the BIND DNS server and how to configure the service.
:* Use this back end for complex DNS scenarios, you can not configure in the internal DNS.
:* Use this back end for complex DNS scenarios, you can not configure in the internal DNS.

Revision as of 19:05, 19 October 2016

Introduction

In an Active Directory (AD), DNS is a very important service. It is used for:

  • name resolution
  • locating services, such as Kerberos and LDAP
  • locating local domain controllers (DC) when using AD sites. For details, see Active Directory Sites.



Supported DNS Back Ends

Samba supports the following DNS back ends:

  • Default when provisioning a new domain, joining an existing domain or migrating an NT4 domain to AD.
  • No additional software or DNS knowledge is required.
  • Use this back end for simple DNS setups. For a list of limitations, see Limitations.
  • Requires BIND 9.8 or later installed and configured locally on the Samba Active Directory (AD) domain controller (DC). For additional information, see Setting up a BIND DNS Server.
  • Requires knowledge about the BIND DNS server and how to configure the service.
  • Use this back end for complex DNS scenarios, you can not configure in the internal DNS.
  • Do not use this back end! It is not supported and will be removed in the future.

If you are unsure which DNS back end to select during the DC installation, start with the Samba internal DNS. You can anytime change the back end. For details, see Changing the DNS Back End of a Samba AD DC.



Selecting the AD Forest Root Domain

Before you provision your Active Directory (AD), you must select a DNS zone for your AD forest root domain. For details, see Active Directory Naming FAQ.

Best practices:

  • Use a domain name you own.
  • Use a subdomain of your domain, such as ad.example.com.
  • Do not use .local domains. They can cause problems with MacOSX and Zeroconf.

For details, see Active Directory Naming FAQ.