Difference between revisions of "Samba AD on CentOS7"

From SambaWiki
Line 47: Line 47:
==Services configuration==
==Setup services==
Here there is a TODO, you can map what you need to set on Selinux, or disable it:
Here there is a TODO, you can map what you need to set on Selinux, or disable it:
setenforce 0
setenforce 0

Revision as of 12:34, 20 August 2015

This page describe Samba4 Active Directory installation on CentOS. The environment is composed of 2 DCs with replication, and one fileserver.




The installation is based on CentOS7 Minimal ISO, you should update the system, and install basic tools.

yum update
yum install -y vim wget


This pre-setup can be done in all 3 servers, basically it will setup the Sernet Samba Repository and install samba from repo.

wget https://raw.githubusercontent.com/hflautert/lotus7/master/samba4/pre_install_samba4.sh
chmod +x pre_install_samba4.sh

DC1 Setup

First of all we need a domain, so lets provision it.

samba-tool domain provision --use-rfc2307 --interactive

DC2 Setup

Setup kerberos, you can use the as dc1.

scp root@dc1.domain.com.br:/etc/krb5.conf /etc/krb5.conf

Join as DC.

samba-tool domain join domain.com.br DC -Uadministrator --realm=domain.com.br

Fix DNS if it was not created automatically:

samba-tool dns add dc1 domain.com.br dc2 A <IP-OF-DC2> -Uadministrator

After couple minutes, we can see the replication:

samba-tool drs showrepl

Post Setup

This post setup will configure the services to startup and disable Selinux and Firewall, during my tests firewalld did not save the allowed ports, even with permanent flag, so I´v decided to disable to avoid problems.

wget https://raw.githubusercontent.com/hflautert/lotus7/master/samba4/post_install_samba4.sh
chmod +x post_install_samba4.sh

Fileserver Setup

The pre-setup is the same, but we are not going provision neither join, the fileserver will be just a member of domain. CentOS bring us a useful tool to do it, actually we are going to setup authentication and join the domain in one shot.

Prep, auth and join

Lets start testing our DNS:

host -t SRV _ldap._tcp.domain.com.br.
_ldap._tcp.domain.com.br has SRV record 0 100 389 dc1.domain.com.br.

Setup auth and join the domain:



Services configuration

Here there is a TODO, you can map what you need to set on Selinux, or disable it:

setenforce 0
sed -i 's/SELINUX=enforcing/SELINUX=disabled/g' /etc/selinux/config

Setup samba start mode

sed -i 's/SAMBA_START_MODE="none"/SAMBA_START_MODE="classic"/g' /etc/default/sernet-samba

Restart services

systemctl restart sernet-samba-smbd
systemctl restart sernet-samba-nmbd
systemctl restart sernet-samba-winbindd

Configurte startup

chkconfig sernet-samba-nmbd on
chkconfig sernet-samba-smbd on
chkconfig sernet-samba-winbindd on