Samba AD DC Port Usage
If you need to secure your Samba installation with a firewall, you will need to know what ports and protocols are used. This page supplies an overview.
Identify on which ports and interfaces Samba is listening
You can use "netstat" to identify which ports Samba and related daemons are listening on and on which IPs:
# netstat -tulpn | egrep "samba|smbd|nmbd|winbind"
The following is a snippet of an example output:
tcp 0 0 127.0.0.1:139 0.0.0.0:* LISTEN 43270/smbd tcp 0 0 10.0.0.1:139 0.0.0.0:* LISTEN 43270/smbd tcp 0 0 10.0.0.1:88 0.0.0.0:* LISTEN 43273/samba tcp 0 0 127.0.0.1:88 0.0.0.0:* LISTEN 43273/samba tcp 0 0 127.0.0.1:445 0.0.0.0:* LISTEN 43270/smbd tcp 0 0 10.0.0.1:445 0.0.0.0:* LISTEN 43270/smbd .....
The above example shows, that the services are listening on localhost (127.0.0.1) and the interface with IP 10.0.0.1 - each on the listed ports (139, 88, 445,...).
Port usage when Samba runs as an Active Directory Domain Controller
|End Point Mapper (DCE/RPC Locator Service)||135||tcp|
|NetBIOS Name Service||137||udp|
|SMB over TCP||445||tcp|
|LDAPS (only if "tls enabled = yes")||636||tcp|
|Dynamic RPC Ports*||1024-5000||tcp|
|Global Cataloge SSL (only if "tls enabled = yes")||3269||tcp|
* Samba, like Windows, supports dynamic RPC services. The range starts at 1024. If something occupies this port for some reason, it will be a different port (literally walked up from 1024).
Remember, that there can be other ports too, which are related to your Samba installation but not provided from Samba itself, like if you run a NTP server for time synchronisation as well.
Prevent Samba from listening on all interfaces
Sometimes you don't want Samba to listen on all interfaces of your host. For example, when the host is directly connected to the internet, you surely don't want to provide your shares to the rest of the world. If you limit Samba to listen only on the internal NIC(s), you don't need a firewall to prevent access from the outside.
Add the following to the "[global]" section of your smb.conf to bind Samba to eth0 and loopback:
bind interfaces only = yes interfaces = lo eth0
The "interfaces" parameter allows various ways to restrict. See the manpage for more details.
After the changes, restart Samba.