GlusterFS is a free and open source scalable filesystem it can be used for cloud storage or to store data in a local network. It can be used to set up an active-active filesystem cluster with failover and loadbalancing via DNS-round robin. Together with CTDB it is possible to build a fileserver for a network with the following advantages:
- Expandable without downtime
- Mount Gluster volumes via the network
- Posix ACL support
- Different configurations possible (depending of your needs)
- Support of snapshots if LVM2 thinly provisioned is used for the bricks
The different configurations available are:
- Replicated Volume
- Distributed Volume
- Striped Volume
- Replicated-Distributed Volume
- Dispersed Volume
To read more about the different configurations see:
|This article is part of CTDB-setup so it just shows how to setup a replicated volume to be used with CTDB. The setup will be a two node replicated volume with 2GB diskspace, so it will be easy to reproduce the setup.|
What you need
- Two hosts with two network cards
- An empty partition of 2GB to create the volume on each host
- Two IP addresses from your production network
- Two IP addresses for the heartbeat network
- The GlusterFS packages version 7.x
Hostnames and IPs
Here you see two tables with the used IP-addresses on both hosts.
If a client should connect to the Gluster-cluster an IP-address from the production network is used.
The heartbeat network is only for the communication between the Gluster-nodes
you need two mountpoints, one for the physical brick and one for the volume.
|Mountpoint||What to mount|
|/gluster||The brick on each node|
|/glusterfs||For the volume on each node|
Setting up the LVM-partition
The first step will be, setting up the replicated Gluster-Volume with two nodes. As an example a partition with 2GB is used.
root@cluster-01:~# fdisk /dev/sdc
root@cluster-01:~# apt install lvm2 thin-provisioning-tools
root@cluster-01:~# pvcreate /dev/sdc1
Physical volume "/dev/sdc1" successfully created.
root@cluster-01:~# vgcreate glustergroup /dev/sdc1
Volume group "glustergroup" successfully created
root@cluster-01:~# lvcreate -L 1950M -T glustergroup/glusterpool
Using default stripesize 64,00 KiB Rounding up size to full physical extent 1,91 GiB Logical volume "glusterpool" created.
root@cluster-01:~# lvcreate -V 1900M -T glustergroup/glusterpool -n glusterv1
Using default stripesize 64,00 KiB. Logical volume "glusterv1" created.
root@cluster-01:~# mkfs.xfs /dev/glustergroup/glusterv1
root@cluster-01:~# mkdir /gluster2
root@cluster-01:~# mount /dev/glustergroup/glusterv1 /gluster2
root@cluster-01:~# echo /dev/glustergroup/glusterv1 /gluster2 xfs defaults 0 0 >> /etc/fstab
root@cluster-01:~# mkdir /gluster2/brick