GlusterFS

Fundamentals

GlusterFS is a free and open source scalable filesystem it can be used for cloud storage or to store data in a local network. It can be used to set up an active-active filesystem cluster with failover and loadbalancing via DNS-round robin. Together with CTDB it is possible to build a fileserver for a network with the following advantages:

• Expandable without downtime
• Mount Gluster volumes via the network
• Posix ACL support
• Different configurations possible (depending of your needs)
• Self-healing
• Support of snapshots if LVM2 thinly provisioned is used for the bricks

The different configurations available are:

• Replicated Volume
• Distributed Volume
• Striped Volume
• Replicated-Distributed Volume
• Dispersed Volume

To read more about the different configurations see:

This article is part of CTDB-setup so it just shows how to setup a replicated volume to be used with CTDB. The setup will be a two node replicated volume with 2GB diskspace, so it will be easy to reproduce the setup.

What you need

• Two hosts with two network cards
• An empty partition of 2GB to create the volume on each host
• Two IP addresses from your production network
• Two IP addresses for the heartbeat network
• The GlusterFS packages version 7.x

Hostnames and IPs

Here you see two tables with the used IP-addresses on both hosts.

production network

If a client should connect to the Gluster-cluster an IP-address from the production network is used.

Hostname	IP-address
cluster-01	192.168.56.101
cluster-02	192.168.56.102

Heartbeat network

The heartbeat network is only for the communication between the Gluster-nodes

Hostname	IP-address
c-01	192.168.57.101
c-02	192.168.57.102

The mountpoints

you need two mountpoints, one for the physical brick and one for the volume.

Mountpoint	What to mount
/gluster	The brick on each node
/glusterfs	For the volume on each node

The first step will be, setting up the replicated Gluster-Volume with two nodes.