Introduction

Samba enables you to change switch between the INTERNAL_DNS and BIND9_DLZ DNS back end on your Active Directory (AD) domain controller (DC) without losing data.

Changing From the Samba Internal DNS Server to the BIND9_DLZ Back End

Run on your domain controller (DC):

Set up and configure the BIND9_DLZ back end. For details, see BIND9_DLZ Back End.

Shut down the Samba service.

Migrate the back end:

# samba_upgradedns --dns-backend=BIND9_DLZ

Use one of the following ways to disable the internal DNS in your smb.conf file:

If you have a server services parameter, remove the dns option. For example:

server services = s3fs, rpc, nbt, wrepl, ldap, cldap, kdc, drepl, winbindd, ntp_signd, kcc, dnsupdate

If you do not have a server services parameter, add the following line:

server services = -dns

Enable the BIND service to start at boot time. See your distribution's documentation for details.

Start the BIND service.

Start the Samba service.

Changing From the BIND9_DLZ Back End to the Samba Internal DNS Server

Run on your domain controller (DC):

Shut down the BIND service.

Disable the automatic start of the BIND service at boot time. See your distribution's documentation for details.

Shut down the Samba service.

Migrate the back end:

# samba_upgradedns --dns-backend=SAMBA_INTERNAL

Use one of the following ways to disable the BIND9_DLZ module in your smb.conf file::

If you have a server services parameter, add the dns option. For example:

server services = s3fs, rpc, nbt, wrepl, ldap, cldap, kdc, drepl, winbindd, ntp_signd, kcc, dnsupdate, dns

If you only have the -dns option listed in the server services parameter, remove the entire parameter:

server services = -dns

Start the Samba service.

The internal DNS is one of the default settings of the server services parameter. Removing the server services parameter enables all the default servers including the DNS server.