Build Samba from Source: Difference between revisions
(Remove Samba 3.x specific build instructions, which is no longer maintained) |
(add path to man pages) |
||
Line 56: | Line 56: | ||
# make install |
# make install |
||
If the man pages are not found, add this line to /etc/manpath.config |
|||
# MANDATORY_MANPATH /usr/local/samba/share/man |
|||
= Upgrading a source version = |
= Upgrading a source version = |
Revision as of 09:12, 30 October 2014
Introduction
This document describes how to build Samba from source.
It can be used for any kind of Samba installation (Samba AD DC, Member Server, Samba PDC, etc.).
Samba Operating System Requirements
See OS Requirements.
Obtaining Samba
See Obtaining Samba.
Compile Samba
To build Samba, run the following commands out of the root of your Samba source directory:
$ ./configure $ make
The above command will setup Samba to install in /usr/local/samba/.
It's recommended to run
$ ./configure --help
to check out the possible configure options, to adapt your installation.
If you are using a development version of Samba or require a build with extra debug information, that may help to diagnose in case of failure, add the following option to „configure“:
--enable-debug
To include the Samba selftest („make test“) in the build, add the following option to „configure“:
--enable-selftest
Install Samba
To install Samba, run the following command in your Samba source directory as user „root“:
# make install
If the man pages are not found, add this line to /etc/manpath.config
# MANDATORY_MANPATH /usr/local/samba/share/man
Upgrading a source version
See Updating Samba.